Automatic PCB Cutting, the main features:
1. Transparent safety door design, so that the processing process at a glance, open the door to stop emergency processing to prevent accidents, to provide a safe inspection of the operating environment. The same time as
2. Automatic MARK point positioning correction system, the mobile path has a real-time display and simulation route tracking, display at a glance, automatic alignment correction function, cutting accuracy is higher, PCB as long as 80mm2
Within the scope of the release, the machine vision can be automatic route correction, to relax the operator in the release board when the accuracy requirements. Greatly improving the work efficiency. The same time as
3. Configure high-pixel CCD zoom lens, auxiliary program teaching and editing functions, higher precision and more accurate, more clear image. Convenient block program and single-step editing and editing. The same time as
4.CCD alignment, before cutting can simulate the path. Reduce unnecessary mistakes. The same time as
5. Tool life monitoring, milling cut the industry will automatically rise and fall to another section of the cutting edge position, the distance and the number of times can be set according to the length of the blade to extend the cutter life. The same time as
6. Two platforms interact with the PCB of the loading and unloading device, can effectively reduce the machine idle time, so as to achieve the desired production efficiency.
Although the visual automatic
PCB cutting has superior processing performance and processing range, but the visual automatic PCB Cutting using the efficiency and service life are inseparable from the visual automatic
PCB Cutting usually maintenance, then how to properly use the maintenance? The following is the main four-point maintenance methods:
1, in the visual automatic PCB Cutting use, first to carry out cleaning and maintenance, the specific method of operation with the appropriate sprinkling to clean the various parts, and it dust inside the dust dilution clean to ensure its clean use. The same time as
2, the visual automatic PCB Cutting Milling cutter if the use of abnormal vibration or sound, you need to stop it to check, in the inspection, to ensure that the power is off the state in the inspection. The same time as
3, in the cleaning and maintenance, sprinkle what dirt is not due to fall into the spindle, because it is the visual automatic PCB Cutting core total, so as not to affect its normal work. The same time as
4, visual automatic PCB Cutting Slot and bearing maintenance, the need for appropriate time to increase the amount of lubricants to maintain, while the loose parts need to tighten.
